|
The Ritz Model A is an American ultralight aircraft that was designed by Gerry Ritz in 1984 and supplied in the form of plans for amateur construction.〔Cliche, Andre: ''Ultralight Aircraft Shopper's Guide'' 8th Edition, page E-31. Cybair Limited Publishing, 2001. ISBN 0-9680628-1-4〕 The aircraft is noted because the designer died while test flying the aircraft, due to a design flaw.〔 ==Design and development== The Model A was designed as a very low-cost aircraft to comply with the US FAR 103 Ultralight Vehicles rules, including the category's maximum empty weight of . The aircraft has a standard empty weight of . It features a strut-braced parasol-wing, a single-seat, open cockpit, conventional landing gear and a single engine in pusher configuration.〔 The aircraft is made predominately from wood, with some steel and aluminum also used. The fuselage is formed as a wooden geodetic lattice structure. Its span wing is supported by a single lift strut per side, with jury struts and cabane struts. The aircraft is covered in doped aircraft fabric. The pilot is accommodated in the open cockpit, with an optional windshield. The powerplant, specified as a single cylinder, two stroke, carburetted Zenoah G-25 aircraft engine, is mounted behind the pilot and behind the wing, above the fuselage. The main landing gear legs are built from wood laminations. The wings and tailplane can be removed in 20 minutes by two people to permit ground transportation by trailer or for storage.〔 The controls are conventional, but limited in pitch and roll authority, bringing a recommendation by reviewer Andre Cliche not to fly the Model A in windy or turbulent conditions.〔 The designer was flight testing the prototype Model A when it suffered wing aeroelastic flutter. Ritz was killed in the subsequent crash. The flutter was traced to the aileron hinge design, which was later modified to address the issue.〔 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Ritz Model A」の詳細全文を読む スポンサード リンク
|